Dynojet 250iP: Pit Installation Guide - Manual (Page 26)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EDDY CURRENT BRAKE
This section will walk you through removing the eddy current brake (or retarder)
from the crate and attaching the brake to your dyno. To route and wire the
temperature sensor cable and the theta controller to the Breakout board refer to
“Routing the Eddy Current Brake, Battery, and Dyno Power Cables” on page 2-32 and
“Wiring the Breakout Board” on page 2-36.
You will need to provide equipment capable of lifting the eddy current brake off the
crate and into position in your dyno room. You will also need a pair of straps. Dynojet
recommends using continuous nylon loop style straps.
To prevent possible injury, unplug all power cords and disconnect the battery.
P ARTS L IST
The following table lists all of the parts included in the Eddy Current Brake
Installation kit. Check your kit against the parts listed to make sure you have received
all of the parts. If any part is missing, contact Dynojet Technical Support.
part number description quantity
21227107 Retarder Connector Plate (already installed) 2
21629403 Bar, Load Cell 1
36582034 Screw, 3/8"-16 x 1 1/4", BH-FLNG 8
37620622 Woodruff Key, 3/8" x 1 3/8" 1
49950030 Temperature Sensor 1
61228400 Hood, Top, Retarder Module 1
63223700 Retarder Module 1
66411002
or
66411003
Theta-2 Controller 120V
or
Theta-2 Controller 240V
1