Dynojet 250iP: Pit Installation Guide - Manual (Page 37)

I N S T A L L A T I O N
Blower Mounts, Support Arm and Junction Box
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-17
I NSTALLING THE B LOWER M OUNTING P LATE , S UPPORT A RM , AND J UNCTION B OX
The high pressure blowers are an optional accessory. If you did not order high
pressure blowers, you will not need to install the blower mounting plates. Refer page
3-24 to for high pressure blower installation instructions.
1
Secure the blower mounting plate to the pit floor using four 3/8 x 1-inch bolts
and 5/16-inch washers.
Note: The right blower mounting plate is secured under the support arm.
2 Secure the support arm and junction box to the pit floor using four 3/8 x 1-inch
bolts and 5/16-inch washers.
Note: The support arm can be mounted on either side of the dyno.
Figure 2-19: Install the Blower Mounting Plates, Support Arm, and Junction Box
PD039
support arm
blower mount
junction box
blower mount
(under support arm)