Dynojet 250iP: Pit Installation Guide - Manual (Page 88)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 3
Extended Carriage
3-22
I NSTALLING THE E XTENDED T IRE C ARRIAGE
1 Starting from the back of the dyno, slide the carriage under the carriage clamps.
2 Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block.
3 Secure the bearing bracket to the carriage using the four 1/4-20 x 1/2-inch
button-head flange bolts removed earlier.
Figure 3-22: Install the Extended Carriage
TC064
nut block
carriage
clamp
carriage
screw
bearing bracket
carriage