Dynojet 250iP: Pit Installation Guide - Manual (Page 90)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 3
High Pressure Blower
3-24
I NSTALLING THE H IGH P RESSURE B LOWERS
Refer to page 2-16 for blower mount installation instructions.
Repeat the following steps for each blower assembly.
1
Place two 1/4-inch thick poly washers around the pin on the blower mount.
Note: Only use one 1/4-inch thick poly washer with the blower mount installed
with the support arm.
2 Place the lower blower arm over the blower mount pin.
3 Place a 3/8-inch thick metal washer on top of the lower blower arm.
4 Secure the lower blower arm using the clamp lever.
5 Place a 1/8-inch thick poly washer around the pin on the upper blower arm.
6 Insert the pin on the upper arm into the lower arm.
7 Place a 1/8-inch thick poly washer around the pin on the blower assembly.
8 Insert the pin on the blower assembly into the upper arm.
Figure 3-23: Install the High Pressure Blowers
blower
assembly
poly washer
upper arm
poly washer
lower arm
poly washer
clamp lever
blower assembly
blower mount
metal washer
only one 1/4-inch
poly washer