Dynojet 250iP: Pit Installation Guide - Manual (Page 42)

Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-22
A CCESSING THE CPI
The CPI comes wired and ready to install. Should you need to re-route the cables so
they come out a different side of the box, use the following instructions to access the
CPI box.
1
Turn off the power to the dyno. Refer to “Main Dyno Power” on page 3-2 for more
information.
2 Remove the eight button-head screws securing the cover and set aside.
3 Remove the cover and set aside.
4 Open the front panel to access the breakers and Breakout board.
Figure 2-23: Accessing the CPI
PD027
cover
front panel access