Dynojet 250iP: Pit Installation Guide - Manual (Page 49)

I N S T A L L A T I O N
Routing Cables
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-29
8 Secure the cable track bracket to the junction box using two 8-32 screws.
9 Secure the cable track bracket to the wheel clamp using a 1/4-20 screw.
Note: If you do not have the wheel clamp, you will need to install the adapter
bracket to the tire stop using the tire stop hardware.
Figure 2-31: Install the Cable Track
junction box
cable track bracket
wheel clamp
cable track bracket
adapter bracket
tire stop