Dynojet 250iP: Pit Installation Guide - Manual (Page 130)

Model 200iP/250iP Motorcycl Pit Dynamometer Installation Guide
A P P E N D I X B
Locations Using 50 Hz Power (Locations Other than North America and Japan)
B-8
I NSTALLING THE W ALL R ECEPTACLE
The wall receptacle is a single 240 volt 30A dedicated circuit with a ground.
The cable carrying the power to this receptacle should be 4.0 mm
2 (ten gauge) or
larger. Check with local building codes for the correct size.
1
Connect one of the 240V legs to the N terminal (white).
2 Connect the other 240V leg to the L terminal (no color).
3 Connect the ground conductor to the green terminal.
Figure B-2: Wiring the Wall Receptacle
N terminal
(white)
L terminal
ground terminal
(green)