Dynojet 250iP: Pit Installation Guide - Manual (Page 43)

I N S T A L L A T I O N
Routing Cables
Version 2 Model 200iP/250iP Motorcycle Pit Dynamometer Installation Guide
2-23
R OUTING THE C ONTROL P ANEL , P ENDANT C ABLES , AND RPM C ABLE
1 Route the control panel cable (P/N 76951502) from the CPI through the
designated communications pit conduit, through the pit, and out of the pit as
shown.
2 Route the pendant cable from the dyno electronics input/output module through
the same conduit and along the same path as the control panel cable. Refer to
“Dyno Electronics” on page 1-10.
Note: Be sure to keep the power and communications cables in different pit
conduits.
3 Route the RPM induction connection cable from the dyno electronics RPM
module through the same conduit and along the same path as the control panel
cable.
Note: Routing the RPM cable is optional.
4 From the pit, route the cables through the junction box.
Figure 2-24: Route the Control Panel, Pendant Cables, and RPM Cables
PD028A
CPI
dyno
electronics
route communications cables
in designated conduit
route power cables
in designated conduit