Carrier Access Broadmore 1750 - Manual (Page 113)

Broadmore 1750 - Release 4.6 6-15
Electrical Installation
Software
Software
The Broadmore 1750 is delivered with operating software pre-installed. The FIPS
140-2 validated Broadmore/SSHield Management software is installed on each CPU’s
disk-on-chip memory. DSP software code also exists on each NIM and SAM and is
unique for each type of module.
Two programs may be used to communicate with the CPU operating system. These are
the Communication Access Multiplexer Management Interface (CAMMI) and
Command Line Interface (CLI). This manual is based upon CAMMI. For information
on the CLI, see Command Line Interface on page 9-1.