Carrier Access Broadmore 1750 - Manual (Page 97)

Broadmore 1750 - Release 4.6 5-15
Module and Fan Installation
Tools
Tools
The following tools are recommended to install, configure, operate, and maintain the
Broadmore 1750:
#1 flathead screwdriver (for cover and fan tray removal/installation)
Dual jeweler’s flathead/Phillips screwdriver
ESD wrist strap
Other standard installation tools as desired.
Remove Front Chassis Cover
Only the front cover must be removed to install the fan tray.
1. Loosen captive screws securing the front cover and set the cover aside.
2. Connect an ESD wrist strap to the front or rear ESD connector and follow
standard ESD procedures while handling unit components.
WARNING! U SE ESD PRECAUTIONS : W EAR AN ESD GROUNDING
STRAP WHILE HANDLING ANY MODULES OR ACCESSING THE INSIDE OF
THE B ROADMORE 1750. F AILURE TO FOLLOW ESD PROCEDURES MAY
DAMAGE SENSITIVE COMPONENTS AND VOID THE WARRANTY .
Fan Tray Installation
1. The fan tray installs from the front, directly below the modules. Fan tray guides
are provided on each side of the chassis. Slide the fan tray into the guides and
firmly push it into place so that connectors totally seat with the midplane.
2. Tighten the two front panel retaining screws using a flathead screw driver.