Carrier Access Broadmore 1750 - Manual (Page 92)

5-10 Broadmore 1750 - Release 4.6
Module and Fan Installation
SAM Installation
SAM Installation
1. Unstructured DS3-3 and E3-3 SAMs are installed in slots C, F, J, and M.
Structured DS3 SAMs are installed in slots C thru N. The protection SAM is
installed in slot P. All SAMs must be of the same type.
2. Place a SAM in the desired slot. so that it slides smoothly in the top and bottom
card guides and the card connector aligns with the midplane connector.
3. Firmly press the SAM into the chassis until the connectors seat against each
other completely. Use pressure simultaneously at the top and bottom of the
SAM to ensure a proper fit to the midplane.
4. Secure the screws on the top and bottom of the module, being careful not to
over-tighten.
5. Repeat this process to install the other SAMs as desired.
CPU Installation
1. Place the CPU card in slot Q from the front of the chassis so that it slides
smoothly in the top and bottom card guides and the card connector aligns with
the midplane connector.
2. Firmly press the CPU card into the chassis until the connectors seat against
each other completely. Use pressure simultaneously at the top and bottom of
the CPU to ensure a proper fit to the midplane.
3. Secure the screws on the top and bottom of the card, being careful not to over-
tighten.
4. In a similar fashion, install the second CPU in slot R
APM Installation
The APM is shipped factory installed in the right-most slot, labeled APM, which
is to the right of slot S.