Carrier Access Broadmore 1750 - Manual (Page 240)

9-6 Broadmore 1750 - Release 4.6
Command Line Interface
Port Configuration
Port Configuration
This example shows how to use CLI to configure a DS3 port. Follow the steps below
from the initial CLI screen to access the configuration items. The steps shown below
must be entered in sequence one-at-a-time. CLI does not support going directly to the
last screen via a single entry (e.g., a single entry of sys/config/slot/c/port1/
configoperation/show will give an error for unrecognized entry).
Each parameter can be revised. For example, to change the port name to “DS3Port”,
you would enter:
Port name DS3 port