Carrier Access Broadmore 1750 - Manual (Page 152)

7-38 Broadmore 1750 - Release 4.6
Configuration
How to Configure Specific Modules
How to Configure Specific Modules
The NIM and SAM configuration process applies to each module installed in the
system. The parameters vary by module as delineated below. For each module, start the
procedure by following the pull-down sequence shown.
The slot selection screen, as shown below, also displays the current alarm condition of
the module in each slot.
NOTE:
The list above displays only a portion of the available Retry
Cause Codes. Scroll down to view additional codes.
Select System Management
↵
Select Configure
↵
Select Slot
↵
Select the slot with the module to be configured
↵