Carrier Access Broadmore 1750 User Manual
Page 124
7-10
Broadmore 1750 - Release 4.6
Configuration
Ethernet IP Configuration
NOTE:
Changes to the following settings only take effect upon system
reboot:
IP Configuration
CIP Configuration
LANE Configuration
Redundancy (APS) Configuration
UNI Version Configuration
Cause Code changes
ATM Address Changes
On initial setup, configure all of these items before doing a system reboot.
Subnet is the mask for the network. Subnet and Gateway are assigned by your facility’s
network administrator. Reboot the Broadmore 1750 to have this IP address take effect.
The entire Broadmore 1750 will reboot with the new IP address. Log into the system
with a valid user ID and password (ID SYSADMIN, password INITIAL).
1. Enter the IP, subnet, and gateway addresses (obtained from the network
administrator). These settings take effect when the Broadmore 1750 is
rebooted.
2. Follow the sequence below to reboot on a single CPU system.
3. Log into the system, and return to the system services configuration screen to
continue the process.
Select Maintenance/Diags.
↵
Select Reboot System
↵