Carrier Access Broadmore 1750 - Manual (Page 241)

Broadmore 1750 - Release 4.6 9-7
Command Line Interface
Port Configuration
Then type show and press Enter to see that the change has taken effect.
Note that the above general commands have two additional items: cancel and save. The
normal way to leave any screen is to enter up, which takes you to the previous
command level. However, this is not allowed on this screen because configuration data
has been altered. This data must be either discarded (cancel) or retained (save) before
proceeding.
The command cardstatus will display a list of all Broadmore 1750 slots with the
module installed. Cardstatus is available when you are in either of the following
command levels:
cli/sys/config/slot
cli/sys/monitor/slot