Carrier Access Broadmore 1750 - Manual (Page 178)

7-64 Broadmore 1750 - Release 4.6
Configuration
PVC Connection
Table 7-18: PVC Configuration Items
The VPI/VCI are locally significant and need to match on both ends of the
PVC. Therefore the VPI/VCI must be provisioned identically on the ATM
switch port.
NOTE:
The transmit and receive VPI/VCI must be configured through
the ATM switch. The procedure for this will vary by switch. Consult the ATM
switch documentation to accomplish this configuration.
Item Definition
Connection Name Press the space bar to select Connection Name and type a descriptive identifier (For
example, test port 2).
Local Slot The Local Slot is the chassis slot.
Local Port Number Port number depends on the configuration.
Local Channel Map Channel map depends on the configuration. Channel map only applies to the
Structured DS3 SAMs. There is no channel mapping for the Unstructured DS3 or
Unstructured E3, and this value will be displayed as N/A.
VP/VC (Transmit/
Receive) The maximum settings for VP/VC are allocated using the Max VP/VC feature in
System Services (see
“Max VP/VC” on page 7-20 ). Table 7-1 on page 7-20
shows the valid VP/VC values.
CDV Cell Delay Variation (CDV) is the difference between the expected arrival time and
the actual arrival time of the next cell. This value is expressed in number of cells.
The value can vary from 0 to 255. An initial value of 80 to 100 cells is
recommended.