Carrier Access Broadmore 1750 - Manual (Page 300)

11-34 Broadmore 1750 - Release 4.6
Security Management (FIPS Mode)
Shell Commands (FIPS Mode)
Shell Commands (FIPS Mode)
fipsmode ... 11-34
selftest ... 11-34
settimeout ... 11-35
sshdShow ... 11-35
sshdSessionShow ... 11-37
scp ... 11-38
resetSecurID ... 11-39
zeroize ... 11-40
Authorized Access to Shell Commands ... 11-41
Shell commands are UNIX-like commands provided by the embedded operating
system. Command syntax is available using the “help” command. Authorized Access
to each command is based on the user privilege level.
fipsmode
NOTE:
The procedure for using this command is given in “Enabling FIPS
Mode” on page 11-18 .
The FIPS mode can only be changed by a SuperUser (Crypto Officer). At the
Broadmore prompt, type fipsmode (to see current value) or fipsmode on (to enable) or
fipsmode off (to disable). After executing this command, the Broadmore must be
rebooted for the change to take effect.
selftest
Self-tests of the FIPS algorithms are performed automatically during power-up. A
SuperUser (Crypto Officer) can perform a manual self-test at any time. At the
Broadmore prompt, type selftest. The following message will be displayed if all tests
pass.
AES Passed
DES Passed
TDES Passed