Paxar Monarch 9850 - Manual (Page 204)

283 ENQ Trailer string is too long. Use a maximum of 3
characters.
284 The buffer type must be T (Transmit), R (Receive), I
(Image), F (Format), or D (Downloadable Fonts).
285 The storage device type in the memory configuration
packet must be N (non-volatile RAM) or R (volatile
RAM).
286 The buffer size is invalid.
287 The printhead width must be 0.
288 The battery voltage must be 0 (15-volt battery) or 1
(12-volt battery).
289 The printer address specified in the communication
settings packet must use exactly six characters.
290Action must be 0 (disable), 1 (enable), or 2 (extended)
for the backfeed control packet or the printer is active.
291 Dispense position must be 50 to 200 dots or the printer
is active.
292 Backfeed distance must be 10 to 200 dots or the printer
is active. The backfeed distance can not be greater
than the dispense position.
293 The skip index selection defined in the field must be 0
(disabled) or 1 (enabled). Correct the packet and
resend to the printer.
294 The verifier mode must be 0 (disable) or 1 (enable).
295 The verifier’s cable detect mode must be 0 (no detect),
1 (I/O cable detect), or 2 (I/O and data cable detect).
310Check digit scheme number must be 1 to 10.
311 Modulus must be 2 to 11.
8-14 Diagnostics and Errors