Paxar Monarch 9850 - Manual (Page 34)

B5. supply_posn Supply Position. -300 to 300 in 1/203 inch. 0 is the default.
Adjusts the machine to print at the vertical 0,0 point on the
supply. This adjustment accounts for mechanical tolerances
from machine to machine. The supply position adjustment
only needs to be made on the initial machine setup. Adjust
the supply position if formats do not start at the 0,0 point on
the supply. Increase the supply position to move print up,
decrease to move print down on the label. To verify the 0,0
point, print a test label. See "Printing a Test Label" in Chapter
8 for more information.
If using one-inch RFID supplies, see "One-Inch Feed Length
Guidelines" in Chapter 3 for more information about setting
the supply position.
You can not change the supply position while the printer is
active. Changing the supply position will affect the print
position, dispense position, and backfeed distance. Once the
supply position is set, use the print control packet and
backfeed control packet to adjust printing and the dispense
position.
B6. cut_posn Cut position. -300 to 300 in 1/203 inch. Use 0 for 9403/9825.
Adjusts where the tag is cut. The printer adjusts the cut
position according to the black marks on the supply. You may
need to adjust for aperture supplies. Increase to move the cut
up, decrease to move the cut down.
B7. skip_index Skip index mode. The 9403, 9825, and 9850 printers do not
support skip index mode. If using RFID supplies, see "RFID
Considerations" in Chapter 3 for more information about skip
index mode. Options:
0 Disable skip index mode (default)
1 Enable skip mode. Allows the printer to skip a
sense mark and print an image over multiple labels.
Example { I,B,0,0,1,10,50,1 p }
Indicates black mark and thermal direct stock has been loaded,
causes the printer to operate in on-demand mode, feeds the
supply approximately .05 inches up before printing the format on
each label (10/203 inches), feeds the supply .25 inches (50/203
inches) before cutting, and enables skip index mode.
2-12 Configuring the Printer