Paxar Monarch 9850 - Manual (Page 28)

C o n f i g u r a t i o n P a c k e t H e a d e r
Always include an I, immediately after the left bracket { and
before the packet identifier (A, B, C, etc.). The I parameter
identifies the data stream as a configuration packet.
Include the I parameter with each packet if
you are sending them individually. Include it
only at the beginning of a data stream if you
are sending multiple packets.
This is the syntax to use when you create online configuration
packets:
Syntax
{ Start of Header
I, Configuration Header
1 to 8 optional packets
A, parameter 1...parameter 5
p System Setup
B, parameter 1...parameter 5 p Supply Setup
C, parameter 1...parameter 5 p Print Control
D, parameter 1...parameter 3 p Monetary Formatting
E, parameter 1...parameter 9 p Control Characters
F, parameter 1...parameter 5 p Communication Settings
G, parameter 1...parameter 4 p Backfeed Control
M, parameter 1...parameter 4 p Memory Configuration
} End of Header
Syntax for single packet
{ Start of Header
I, Configuration Packet Identifier
A, parameter 1...parameter 5 System Setup
} End of Header
You can also add a configuration to non-volatile RAM or specify
units for supply, print, margin, and cut positions. If you use the
optional parameters with the
I packet, any online configuration
packets following the split vertical bar ( p ) must specify distances
using the selected units. However, the test labels display the
units in dots, even if you entered them in English or Metrics units.
2-6 Configuring the Printer