Paxar Monarch 9850 - Manual (Page 64)

Example {V,1,A,T,"BEAMON" p
D,"~LV02" p }
The verifier’s configuration packet ID is "1" and named
"BEAMON." The verifier packet is added to temporary memory. It
uses Mode 2.
D e f i n i n g a N e t w o r k C o n s o l e P a c k e t
The network console packet is only valid on a 9855 or 9860
Version 2.0 (or greater) printer containing MonarchNet2

software for the Monarch® 7410
 Ethernet Print Server. Use the
network console packet to send console commands directly to the
network card via the printer’s serial port. If the network card does
not appear to be communicating with the printer, you can use the
network console packet to change the SSID, IP Address, etc. of
the network card.
Syntax {N,number,action,device,"name" p
C,"con_comds" p }
N1. N Network Console Packet.
N2. number Number from 0-999 to identify the network console packet.
N3. action Action. Enter A to add a verifier configuration.
N4. device Storage device. Enter T to pass the packet through the
printer and store the packet in the network card.
N5. "name" Packet name, 0-8 characters, enclose within quotation marks.
C1. C Command field.
C2. "con_comds" Console commands. Must be enclosed within quotation
marks. Each command must be on a separate line. The
maximum number of characters per command is 100. Refer
to the list of console commands in the MonarchNet2
Operating Instructions (available on our Web site) for more
information.
NOTE: The maximum number of commands per packet is
ten (10).
2-42 Configuring the Printer