Paxar Monarch 9850 - Manual (Page 42)

Command Parameter
^PR Resets the printer. This command takes five seconds to complete and then
the printer is ready to receive data. It has the same effect as turning off
and then turning on the printer.
NOTE:
Command should be used only when the printer is not printing.
^RB Repeats the last printed batch, printing the same number of labels as
specified in the original batch. This command does not work if using batch
separators.
NOTE: Printer ignores this command if printing.
^RS Resynchronizes supply when supply roll is changed.
NOTE:
Printer ignores this command if printing.
^SD or
^SCd
Disables the status polling feature by turning off the status polling control
character. Sets the status polling control character to the ASCII value
given by the d parameter. The value of d can be any ASCII character.
^SFa Loads script with host response (9825/985x/9860)
^SFb Loads script without host response (9825/985x/9860).
^SFc Enables script (9825/985x/9860).
^SFd Disables script (9825/985x/9860).
^SFe Uploads script version information (9825/985x/9860).
^SFf Deletes script (9825/985x/9860).
^SFg Turns on ENQ status polling before it reaches the script (9825/985x/9860).
^SFh Turns off ENQ status polling before it reaches the script (9825/985x/9860).
^SFi Turns on immediate commands before it reaches the script
(9825/985x/9860).
^SFj Turns off immediate commands before it reaches the script
(9825/985x/9860).
^TP Prints a test label set. NOTE: Printer ignores this command if printing.
The table represents the defined immediate command control
character as ^ and the defined status polling control character as
d. You may define these characters to suit your needs.
To use the immediate command control
character or the status polling character
within your data, use the tilde sequence.
2-20 Configuring the Printer