Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 188)

Installing under Windows
174
AX3000 - User's Manual
Select the dialog box of the 'Connection port' (menu [Configuration]-[Ports]-
[xxx]). For example, the Aux1 port:
Set the 'Active' parameter to 'As COM port' or 'As Printer and COM'. Then
select 'COM Port Parameters' and press <Space>. The following box is
displayed:
These parameters are:
- Port Name: redirect COM port name (from COM1 to COM255).
- DSR Signal (only for Aux1 and Aux2): the DSR signal is not supported
by the AX3000 native auxiliary ports. This parameter allows the incoming
DSR value to be emulated. The possible values are: "Always Low",
"Always Up", "Follows CTS" or "Follows CD".
The COM port declaration is completed. For the redirection procedure, consult
the next sub-section. Then consult sub-section d) for remapping procedure.