Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 41)

Interactive Set-Up
AX3000 - User's Manual
27
- Appendix A.2: Ethernet addresses, IP addresses, net masks and routers,
- Appendix A.3: DHCP protocol,
- Appendix A.4: DNS protocol.
3.1.1 - AX3000 Interface
To set the AX3000 interface select the [Configuration]-[TCP/IP]-[Interface]
menu. The dialog box below is displayed:
This dialog box changes depending on whether the DHCP protocol is enabled.
a) The DHCP Protocol
The DHCP protocol allows the terminal’s IP address (and other parameters) to
be obtained at the boot time.
When "Enable DHCP" is set to "Yes", the 'AX3000 IP Address' field is not
available and the following DHCP Option List allows certain parameters to be
automatically assigned by DHCP:
- AX3000 Netmask,
- Default router: see Chapter 3.1.4,
- DNS Servers: see Chapter 3.1.2,
- Default DNS Domain: see Chapter 3.1.2.
When <Space> is pressed on "Enhanced Parameters" a dialog box as shown