Axel AX3000 65 User's Manual - firmware 0632 User Manual

Page 227

Advertising
background image

Remote

Administration


AX3000 - User's Manual

213

AX3000 must already have been set

10.3.1 - AX3000 Remote Set-Up

To set-up an AX3000 remotely, use the 'setup_send' command. Example for
Unix/Linux:

# rsh axname setup_send password < conf_file

Notes:

- The next chapter explains how to create the configuration file conf_file,

either using a text editor or using the 'setup_get' command on an
existing terminal. Appendix A.5 contains a detailed description of the
configuration file.

- password: specify the password if the set-up is password-protected.

The message 'Store set-up in progress...' is displayed on the
operator’s console while the remote command is processing. If a connection
problem occurs, a time-out error message is displayed.

When the configuration has been successfully completed, the message 'OK,
set-up updated' is displayed on the operator’s console. If other messages
are displayed, refer to Chapter 10.3.3.

The AX3000 must read this new set-up before it will take effect. This can be
achieved either by power-cycling the AX3000 or by the following 'ax_reboot'
command. Example for Unix/Linux:

# rsh axname ax_reboot password

Note about password: specify the password if the set-up is password-
protected.

The message 'Reboot in progress...' is then displayed on the operator’s
console, the AX3000 is reset and the new set-up is implemented. If a
connection problem occurs, a time-out error message is displayed.

10.3.2 - Obtaining a Configuration

To obtain the configuration from an existing AX3000 terminal, use the

Advertising
This manual is related to the following products: