Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 86)

Using the AX3000
72
AX3000 - User's Manual
a) Copy
From a Windows Session (RDP or ICA):
Use the standard 'Copy' function. For example <Ctrl><C>
From a VNC Session:
The 'vncconfig' tool must be run. The copy is simply done by selecting a text
zone.
From a Text Session (5250, 3270, ANSI, VT...):
Press <Ctrl><C> (with 5250 and 3270 emulations) or <Ctrl><Alt><C> (with
other emulations) to enter the Copy mode. Use the mouse to select the copy
data. Pressing <Enter> validates the selection and the text is copied into a local
clipboard. (<Esc> cancels Copy Mode).
Note: the Copy function is available only if the mouse is supported by the
current session.
b) Paste
To Windows Session (RDP or ICA):
Use the standard 'Paste' function. For example <Ctrl><V>
To a VNC Session:
The 'vncconfig' tool must be run. Select 'Paste' in the contextual menu of the
Linux software.
To a Text Session (5250, 3270, ANSI, VT, WYSE...):
Press <Ctrl><V> (with 5250 and 3270 emulations) or <Ctrl><Alt><V> (with
other emulations) to paste the contents of the local clipboard.
Note: for the 5250 and 3270 sessions, a <Field Exit> function is sent at the end
of each line contained in the clipboard.
4.6 - TURNING OFF THE AX3000
A careful check should be made before turning off the TCP/IP AX3000 if TCP/IP
connections are active. The operating system cannot detect if a TCP/IP device