Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 252)

Appendix
238
AX3000 - User's Manual
8-colour format: the 8 available colours are black, red, green,
brown, blue, magenta, cyan and white.
16-colour format: the 8 additional available colours are grey,
lt-magenta, lt-green, hi-white, lt-blue, lt-red, lt-cyan
and yellow.
Resolution: the available resolutions are 800x600-60Hz,
800x600-72Hz, 800x600-75Hz, 800x600-85Hz,
1024x768-60hz, 1024x768-70hz, 1024x768-75hz,
1024x768-85hz, 1280x1024-60hz, 1280x1024-
75hz, 1440x900-60hz and 1440x900-75hz.
In the following parameter lists, the possible values are bracketed after each
set-up parameter.
A configuration file can either be created using a text editor, or obtained from an
already configured TCP/IP AX3000 (by using setup_get remote command).
When a configuration file is obtained from an AX3000, the inactive parameters
(undefined hosts, print server unused, colouring mode disabled, etc) are
commented out.
The sample configuration file, shown In the following pages, is typical of a file
obtained from an already configured AX3000. Notes and headings have been
inserted for clarification and would not appear in the file.
Header
BEGIN_AX_SETUP V1.1
#########################################################
# TCP/IP AX3000 Platine Terminal #
# #
# Ethernet address: 00:A0:34:00:27:10 #
# Firmware: FK5.BV2.1a/TCP.FR.0632b.STD #
#########################################################
#
# RESET_CMOS
Note: the RESET_CMOS command allows all the set-up parameters (except the
AX3000 IP address) to be reset. This line can be deleted or set as a comment.