Super Systems 20Q - Manual (Page 109)

105
Derivative time Derivative time Derivative time Derivative time Derivative time: programmable from 1 second to 10 minutes
or excluded.
Integral pre-load
Integral pre-load Integral pre-load Integral pre-load Integral pre-load: programmable
- for one control output, from 0 to 100% of the output range.
- for two control outputs (split range excluded), from -100 % to
+100 % of the output range.
Anti reset windup Anti reset windup Anti reset windup Anti reset windup Anti reset windup: from 10 % to 200 % of the input span.
Main output cycle time
Main output cycle time Main output cycle time Main output cycle time Main output cycle time: from 1 second to 200 seconds.
Secondary output cycle time
Secondary output cycle time Secondary output cycle time Secondary output cycle time Secondary output cycle time: from 1 second to 200
seconds.
Relative secondary output gain
Relative secondary output gain Relative secondary output gain Relative secondary output gain Relative secondary output gain: keyboard programmable
from 0.20 to 2.00 referred to the proportional band.
Overlap / dead band
Overlap / dead band Overlap / dead band Overlap / dead band Overlap / dead band : keyboard programmable from - 20 %
(dead band) to + 50 % (overlap) of the proportional band.
Output limiters
Output limiters Output limiters Output limiters Output limiters.
For the main and/or secondary control outputs it is possible to
set:
- output high limits
- output low limits
- output max. rate of rise.
AUTO/MANUAL mode
AUTO/MANUAL mode AUTO/MANUAL mode AUTO/MANUAL mode AUTO/MANUAL mode: selectable by front push-button or
logic input.
OUTPUTS OUTPUTS OUTPUTS OUTPUTS OUTPUTS
Control output updating time Control output updating time Control output updating time Control output updating time Control output updating time :
- 125 ms when a linear input is selected
- 250 ms when a TC or RTD input is selected.
Action
Action Action Action Action: direct/reverse programmable
Output level limiter
Output level limiter Output level limiter Output level limiter Output level limiter:
- high and low limits for main control output
- high and low limits for secondary control output.
Out 1 and 2 Out 1 and 2 Out 1 and 2 Out 1 and 2 Out 1 and 2
Function
Function Function Function Function: singularly programmable as
- Control output
- Alarm output
- Event output.
Type
Type Type Type Type: Relay, SSR or TRIAC.
Out 1 and 2 - Relay Out 1 and 2 - Relay Out 1 and 2 - Relay Out 1 and 2 - Relay Out 1 and 2 - Relay
Relay type
Relay type Relay type Relay type Relay type: SPDT
Contact rating
Contact rating Contact rating Contact rating Contact rating: 3 A @ 250 V on resistive load.
mkc-ssi.pmd 06/07/2004, 12.20 105