Super Systems 20Q User Manual

Page 58

Advertising

CnF. 5CnF. 5CnF. 5CnF. 5CnF. 5

- Event 1 function - [C.H07]

This parameter will be available only when OUT 1 is configured
as event annunciator ("O1.Fn" [C.E01] is equal to “Eun.1”).
Range: ñ.In.E=Error condition (Over-Under-Open-Shrt) on main

input (Logic level “1” when error occurs)

Cj.Er = Error condition on CJ measurement (Logic level

“1” when error occurs)

A.In.E= Error condition (Over-Under-Open) on auxiliary

input (Logic level “1” when error occurs)

ñEA.E = Error condition on any measurement (Logic level

“1” when error occurs)

Au.ñA = Auto/manual mode annunciator (Logic level “1”

when device is in manual mode)

SP.L.r = Local/Remote set point annunciator (Logic level

“1” when remote set point is used)

- Event 1 contact status - [C.H08]

This parameter will be available only when OUT 1 is configured
as event annunciator ("O1.Fn" [C.E01] is equal to “Eun.1”).
Range: CLSd = The output is at logic level “1” when contact is

closed

OPEn = The output is at logic level “1” when contact is

open

- Event 2 function - [C.H09]

This parameter will be available only when OUT 2 is configured
as event annunciator ("O2.Fn" [C.E02] is equal to “Eun.2”).
Range: ñ.In.E=Error condition (Over-Under-Open-Shrt) on main

input (Logic level “1” when error occurs)

Cj.Er = Error condition on CJ measurement (Logic level

“1” when error occurs)

A.In.E= Error condition (Over-Under-Open) on auxiliary

input (Logic level “1” when error occurs)

ñEA.E = Error condition on any measurement (Logic level

“1” when error occurs)

Au.ñA = Auto/manual mode annunciator (Logic level “1”

when device is in manual mode)

SP.L.r = Local/Remote set point annunciator (Logic level

“1” when remote set point is used)

mkc-ssi.pmd

06/07/2004, 12.19

Advertising

Popular Brands

Popular manuals