Super Systems 20Q - Manual (Page 85)

Gr.5Gr.5Gr.5Gr.5Gr.5
81
- Main control output max rate of rise - - Main control output max rate of rise - - Main control output max rate of rise - - Main control output max rate of rise - - Main control output max rate of rise -
[r.E06] [r.E06] [r.E06] [r.E06] [r.E06]
This parameter is available when one control output is configured
as main output.
Ranges: from 0.1%/s to 25.0%/s.
Above this value the display shows “Inf” meaning that no limit is
imposed
NOTES
NOTES NOTES NOTES NOTES:
1) This parameter will be active even if device is configured for
On/OFF control.
2) During the transfert from AUTO to MANUAL, if this action is
programmed as a not bumpless transfer, the “ñ.rñP” function
will be ignored and the output will step up to the value set by
“Añ.UL” [C.G04] parameter.
- Main output cycle time - [r.E07] - Main output cycle time - [r.E07] - Main output cycle time - [r.E07] - Main output cycle time - [r.E07] - Main output cycle time - [r.E07]
This parameter is available when time proportional main control
output is configured.
Range: from 1 to 200 s
- Secondary control output low limit - - Secondary control output low limit - - Secondary control output low limit - - Secondary control output low limit - - Secondary control output low limit -
[r.E08] [r.E08] [r.E08] [r.E08] [r.E08]
This parameter is available when one control output is configured
as secondary control output.
Range: From 0.0 % of the output span to S.OLH [r.E09].
- Secondary control output high limit - - Secondary control output high limit - - Secondary control output high limit - - Secondary control output high limit - - Secondary control output high limit -
[r.E09] [r.E09] [r.E09] [r.E09] [r.E09]
This parameter is available when one control output is configured
as secondary control output.
Range: from S.OLL [r.E08] to 100.0 % of the output span
- Secondary control output max rate of - Secondary control output max rate of - Secondary control output max rate of - Secondary control output max rate of - Secondary control output max rate of
r i s e r i s e r i s e r i s e r i s e- [r.E10] - [r.E10] - [r.E10] - [r.E10] - [r.E10]
This parameter is available when one control output is configured
as secondary control output.
Ranges: from 0.1%/s to 25.0%/s.
Above this value the display shows “Inf” meaning that no limit is
imposed
mkc-ssi.pmd 06/07/2004, 12.19 81