Super Systems 20Q User Manual

Page 99

Advertising

Gr.7Gr.7Gr.7Gr.7Gr.7

Relative gain of the secondary

output calculated by SMART algorithm - [r.L05]

output calculated by SMART algorithm - [r.L05]
This parameter is available only when smart function is
configured (“Sñ.Fn” [C.G01] = “Enb”) and a secondary control
output (without split range) is configured.
Range: OFF = Smart algorithm does not calculate “r.Gn”

[r.d06] value.

= Smart algorithm calculates “r.Gn” [r.d06] value.

- Hidden group default data loading -

[r.L06]

Range: OFF = No loading data

On = loading data

ERROR MESSAGES

OVERRANGE, UNDERRANGE AND SENSOR

OVERRANGE, UNDERRANGE AND SENSOR
LEADS BREAK DETECTION

LEADS BREAK DETECTION

ON THE MAIN INPUT

The device is capable to detect a fault condition on the main
input (OVERRANGE or UNDERRANGE or SENSOR LEADS
BREAK).
When the process variable exceeds the full scale value
programmed by "ñ.In.t" [C.d02], an OVERRANGE condition will be
shown on the upper display as show in the following figure:

When the process variable is lower than the initial scale value
programmed by "ñ.In.t" [C.d02], an UNDERRANGE condition will
be shown on the upper display as show in the following figure:

In presence of an main input out-of-range condition, the control
outputs operate as follows:

mkc-ssi.pmd

06/07/2004, 12.20

Advertising

Popular Brands

Popular manuals