Super Systems 20Q - Manual (Page 60)

CnF. 5CnF. 5CnF. 5CnF. 5CnF. 5
56
- Event 4 contact status - [C.H14] - Event 4 contact status - [C.H14] - Event 4 contact status - [C.H14] - Event 4 contact status - [C.H14] - Event 4 contact status - [C.H14]
This parameter will be available only when OUT 4 is configured
as event annunciator ("O4.Fn" [C.E04] is equal to “Eun.4”).
Range: CLSd = The output is at logic level “1” when contact is
closed
OPEn = The output is at logic level “1” when contact is
open
General notes on configuration group 5 General notes on configuration group 5 General notes on configuration group 5 General notes on configuration group 5 General notes on configuration group 5
1) Digital input function selection should be “consistent” with other
configuration parameters otherwise this digital input will remain
unused.
2) Changing menu the device will check that the same function is
not assigned to more than one digital input, otherwise the display
will show:
CONFIGURATION GROUP 6 [C.Ixx] CONFIGURATION GROUP 6 [C.Ixx] CONFIGURATION GROUP 6 [C.Ixx] CONFIGURATION GROUP 6 [C.Ixx] CONFIGURATION GROUP 6 [C.Ixx]
OTHERS CONFIGURATION PARAMETERS
- Green bargraph function - [C.I01] - Green bargraph function - [C.I01] - Green bargraph function - [C.I01] - Green bargraph function - [C.I01] - Green bargraph function - [C.I01]
This parameter will be available for MKC models only.
Range: Pr.Ur = the green bargraph will show the process
variable value
DEV. = the green bargraph will show the deviation
(measured value minus set point)
- Orange bargraph function - [C.I02] - Orange bargraph function - [C.I02] - Orange bargraph function - [C.I02] - Orange bargraph function - [C.I02] - Orange bargraph function - [C.I02]
This parameter will be available for MKC models only.
Range: OP.SP= On bargraph is shown the operative set point
value
P.Out. = On bargraph is shown the process output value
mkc-ssi.pmd 06/07/2004, 12.19 56