Super Systems 20Q - Manual (Page 33)

29
NOTES NOTES NOTES NOTES NOTES:
1) During monitor mode, the instrument continues to operate as
in run time mode.
2) During monitor mode, if no push-button is depressed for more
than 10 s (or 30 s according to "t.out" [C.I10] parameter
setting), the instrument returns automatically to the normal
display mode.
MODIFY MODE MODIFY MODE MODIFY MODE MODIFY MODE MODIFY MODE
1) By or push-button select the modify mode.
2) Push the MENU push-button.
If a security code is applied to the configuration parameter,
the instrument will show:
3) By and push-button set a value equal to the security
code assigned to the configuration mode (see "Configuration
security code " at page 25).
If the code is different from the security code, the instrument
automatically returns to the first configuration display
otherwise the display will show:
The modify mode is started.
This display allows you to load the default configuration
parameter.
For more details see chapter "Default parameter" (see
Appendix A).
mkc-ssi.pmd 06/07/2004, 12.19 29