Super Systems 20Q - Manual (Page 74)

70
RUN TIME PARAMETER MODIFICATION. RUN TIME PARAMETER MODIFICATION. RUN TIME PARAMETER MODIFICATION. RUN TIME PARAMETER MODIFICATION. RUN TIME PARAMETER MODIFICATION.
By “MENU” push-button it is possible to start the run time
parameter modification by selecting desired run time parameter
group.
During the run time parameter modification, the upper display
shows the selected parameter group, the lower display shows
the mnemonic code of the selected parameter while the central
display shows the value or status assigned to the selected
parameter.
The parameter monitoring and modification are subjected to a
time out (see “t.out” [C.I10] parameter) after that the display
returns in “Normal display mode” and the eventual modification
on the last displayed parameter will be lost.
NOTES NOTES NOTES NOTES NOTES:
1) In the following pages we will describe all the parameter of
the instrument but it will show only the parameters related
with the specific hardware and in accordance with the
specific instrument configuration.
2) If all the parameters of a group are not available, the
instrument will not display this group.
3) For an easy consultation of the manual, it is accompanied by
a table with all the run time parameter visualization.
PARAMETER PROTECTION PARAMETER PROTECTION PARAMETER PROTECTION PARAMETER PROTECTION PARAMETER PROTECTION
Moving from one run time parameter group to another, the
instrument will show, at first, the group number (on the upper
display), the mnemonic code (on the lower display) and the
security status (on the middle display) of the group.
The possible security status are:
Enb
= the parameters of this group are not protected and they
may be modified;
inh = the parameters of this group are ever protected and they
cannot be modified
- - - - = the parameters of this group are software protected.
In this case, using “ “ and “ ” push-button set a value
equal to the security code programmed during the "Run
time security code " (see page 23) and then push
“FUNC”.
If the programmed value matches the security code the
parameters of this group can be modified otherwise they
remain protected.
ATTENTION ATTENTION ATTENTION ATTENTION ATTENTION: One software key protects one or more run time
parameter groups so that when the software key is inserted, it is
possible to modify the run time parameters of all groups.
The software protection will be automatically restored when the
instrument comes back to the "normal display mode" (by "MENU"
push-button pressure or by the time out).
mkc-ssi.pmd 06/07/2004, 12.19 70