Super Systems 20Q - Manual (Page 110)

106
Out 1 and 2 - SSR Out 1 and 2 - SSR Out 1 and 2 - SSR Out 1 and 2 - SSR Out 1 and 2 - SSR
Type: not
Type: not Type: not Type: not Type: not isolated voltage output
- Logic level 1:
14V @ 20 mA max.
24 V @ 1 mA.
- Logic level 0:
< 0.5 V D.C.
Out 1 and 2 - TRIAC Out 1 and 2 - TRIAC Out 1 and 2 - TRIAC Out 1 and 2 - TRIAC Out 1 and 2 - TRIAC
Switching mode
Switching mode Switching mode Switching mode Switching mode: isolated zero crossing type.
Rated current
Rated current Rated current Rated current Rated current: from 50 mA to 1 A.
Rated voltage
Rated voltage Rated voltage Rated voltage Rated voltage: from 24 V
RMS
to 240 V
RMS
-10% +15% (50-60
Hz).
Load type
Load type Load type Load type Load type: resistive load only
IIIII
22222 t for external fuse t for external fuse t for external fuse t for external fuse t for external fuse: 128
Out 3 and 4 Out 3 and 4 Out 3 and 4 Out 3 and 4 Out 3 and 4
Function
Function Function Function Function: singularly programmable as:
- Control output
- Alarm output
- Event output.
- Servomotor drive (Out 3 , out 4 )
Type
Type Type Type Type: Relay .
Relay type
Relay type Relay type Relay type Relay type: SPST
Contact rating
Contact rating Contact rating Contact rating Contact rating: 3 A @ 250 V on resistive load.
Notes Notes Notes Notes Notes:
1) The commons of the out 3 and 4 are connected together with
the same rear terminal.
2) When OUT 3 and 4 are used as independent relay outputs the
addition of the two currents must not exceed 3 A.
Servomotor output Servomotor output Servomotor output Servomotor output Servomotor output
Type
Type Type Type Type: Two relays with interlocked contact (Out 3 and 4).
Servomotor output type:
Servomotor output type: Servomotor output type: Servomotor output type: Servomotor output type:
- Close loop
- Open loop with feedback for valve position indication only
- Open loop without feedback.
Feedback potentiometer input
Feedback potentiometer input Feedback potentiometer input Feedback potentiometer input Feedback potentiometer input: from 100 Ω to 10 k Ω .
Servomotor travel time Servomotor travel time Servomotor travel time Servomotor travel time Servomotor travel time: From 12 s to 3 minutes.
Servomotor dead band
Servomotor dead band Servomotor dead band Servomotor dead band Servomotor dead band: From 1 % to 50 % of the feedback
span or of the valve travel time.
Analog outputs Analog outputs Analog outputs Analog outputs Analog outputs
Out 5 and 6 Out 5 and 6 Out 5 and 6 Out 5 and 6 Out 5 and 6
Function
Function Function Function Function: Programmable as
- Control output
- Analog retransmission of the measured value
- Analog retransmission of the operative set point.
mkc-ssi.pmd 06/07/2004, 12.20 106