Super Systems 20Q User Manual

Page 50

Advertising

CnF. 3CnF. 3CnF. 3CnF. 3CnF. 3

AFtr

= The functions listed at Note (**) are calculated

after

after to apply the action selected by “ñC.Cn”
(“Main control output conditioning” [C.F06])
parameter.

Note (**)

Note (**)
- "Main control output limiters" - for more details see [r.E04] and

[r.E05] parameters.

- "Main control output max rate of rise" (see [r.E06]).
- "Control output display value" - for more details see "Display

function" paragraph at pag. 62 and [C.F07], [C.F08], [C.F09]
and [C.F10] parameters.

- "Threshold for alarm on control output value" - for more details

see [r.F01], [r.F05] [r.F09] and [r.F13] parameters.

- The control output value displayed by bargraph.

- Secondary control output conditioning

- [C.F12]

This parameter will be available only when secondary control
output is configured.
Range: norñ = The control output is calculated by the PID

CñPL = The control output is complemented (100-PID

calculated value)

Ouic = The control output is conditioned to match a

“QUICK OPENING” flow characteristic

Eou

= The control output is conditioned to match an

“EQUAL PERCENTAGE” flow characteristic

For more details see also NOTE about output conditioning

NOTE about output conditioning

at page 43.

- Secondary control output in engineer-

ing unit - [C.F13]

This parameter will be available only when secondary control
output is configured.
Range: nO

= Scalable is not required

YES

= Scalable is required

NOTE

NOTE: This scaling allows to display the output value in
engineering units instead of in percent.

- Secondary control output decimal point

position - [C.F14]

This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range:

----.

= No decimal figure

---.-

= One decimal figure.

--.--

= Two decimal figures.

mkc-ssi.pmd

06/07/2004, 12.19

Advertising

Popular Brands

Popular manuals