Super Systems 20Q User Manual

Page 86

Advertising

Gr.5Gr.5Gr.5Gr.5Gr.5

NOTES

NOTES:
1) This parameter will be active even if device is configured for

On/OFF control.

2) During the transfer from AUTO to MANUAL, if this action is

programmed as a not bumpless transfer, the “S.rñP” function
will be ignored and the output will step up to the value set by
“Añ.UL” [C.G04] parameter.

- Secondary output cycle time - [r.E11]

This parameter is available when a time proportional secondary
control output is configured.
Range: from 1 to 200 s

- Set point low limit - [r.E12]

Range: From “ñ.In.L” [C.d05] to rH [r.E13].
NOTES

NOTES

NOTES: Whenever “ñ.In.L” [C.d05] has been modified, the
following occurs:
1) rL will be realigned to it;
2) if the set point values are out of the new limits, the set point

automatically assumes the default value.

- Set point high limit - [r.E13]

Range: from rL [r.E12] to “ñ.In.H” [C.d06].
NOTES

NOTES

NOTES: Whenever “ñ.In.H” [C.d06] has been modified, the
following occurs:
1) rH will be realigned to it;
2) if the set point values are out of the new limits, "rH"

automatically assumes the default value.

- Rate of change for positive set point

variations - [r.E14]

Range: from 1 to 200 digits per minute.
Above this value the display shows “Inf” and the transfer will be a
step change.

- Rate of change for negative set point

variations - [r.E15]

Range: from 1 to 200 digits per minutes.
Above this value the display shows “Inf” and the transfer will be a
step change.

mkc-ssi.pmd

06/07/2004, 12.19

Advertising

Popular Brands

Popular manuals