H3C Technologies H3C S10500 Series Switches - Manual (Page 163)

148
Task Remarks
Configuring IS-IS link cost Optional
Specifying a priority for IS-IS Required
Configuring the maximum number of equal cost routes Optional
Configuring IS-IS route summarization Optional
Advertising a default route Optional
Configuring IS-IS route redistribution Optional
Configuring IS-IS route filtering Optional
Configuring IS-IS
routing information
control
Configuring IS-IS route leaking Optional
Specifying intervals for sending IS-IS hello and CSNP packets Optional
Specifying the IS-IS hello multiplier Optional
Configuring a DIS priority for an interface Optional
Disabling an interface from sending or receiving IS-IS packets Optional
Enabling an interface to send small hello packets Optional
Configuring LSP parameters Optional
Configuring SPF parameters Optional
Assigning a high priority to IS-IS routes Optional
Setting the LSDB overload bit Optional
Configuring system ID to host name mappings Optional
Tuning and
optimizing IS-IS
networks
Enabling the logging of neighbor state changes Optional
Configuring neighbor relationship authentication Optional
Configuring area authentication Optional
Enhancing IS-IS
network security
Configuring routing domain authentication Optional
Configuring IS-IS GR Optional
Configuring IS-IS FRR Optional
Enabling IS-IS SNMP trap Optional
Binding an IS-IS process with MIBs Optional
Configuring BFD for IS-IS Optional
Configuring IS-IS basic functions
Configuration prerequisites
Before configuring IS-IS basic functions, complete the following tasks:
• Configure the link layer protocol
• Configure an IP address for each interface, and make sure all neighboring nodes are reachable to
each other at the network layer.