H3C Technologies H3C S10500 Series Switches - Manual (Page 288)

273
Displaying and maintaining RIPng
To do… Use the command… Remarks
Display configuration information
of a RIPng process
display ripng [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display routes in the RIPng
database
display ripng process-id database
[ | { begin | exclude | include }
regular-expression ] Available in any view
Display the routing information of
a specified RIPng process
display ripng process-id route [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display RIPng interface information
display ripng process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Reset a RIPng process reset ripng process-id process Available in user view
Clear statistics of a RIPng process reset ripng process-id statistics Available in user view
RIPng configuration examples
Configure RIPng basic functions
Network requirements
In Figure 103 , all switches run RIPng. Configure Switch B to filter the route (3::/64) learned from Switch
C, which means the route will not be added to the routing table of Switch B, and Switch B will not forward
it to Switch A.
Figure 103 Network diagram for RIPng configuration
Configuration procedure
1. Configure the IPv6 address for each interface. (Details not shown)
2. Configure basic RIPng functions.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable