H3C Technologies H3C S10500 Series Switches - Manual (Page 46)

31
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––
Configure the filtering of incoming
routes
filter-policy { acl-number |
gateway ip-prefix-name | ip-prefix
ip-prefix-name [ gateway
ip-prefix-name ] } import
[ interface-type interface-number ]
Required
Not configured by default
Configure the filtering of outgoing
routes
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] |
interface-type interface-number ]
Required
Not configured by default
NOTE:
•
Using the filter-policy import command filters incoming routes. Routes not passing the filtering will be
neither installed into the routing table nor advertised to neighbors.
• Using the filter-policy export command filters outgoing routes, including routes redistributed with the
import-route command.
Configuring a priority for RIP
Multiple IGP protocols can run in a router. If you want RIP routes to have a higher priority than those
learned by other routing protocols, then assign RIP a smaller priority value to influence optimal route
selection.
Follow these steps to configure a priority for RIP:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––
Configure a priority for RIP
preference [ route-policy
route-policy-name ] value Optional
100 by default
Configuring RIP route redistribution
If a router runs RIP and other routing protocols, you can configure RIP to redistribute OSPF, IS-IS, BGP,
static, or direct routes.
Follow these steps to configure RIP route redistribution:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––