H3C Technologies H3C S10500 Series Switches - Manual (Page 42)

27
To do… Use the command… Remarks
Enable the interface to receive RIP
messages
rip input
Optional
Enabled by default
Enable the interface to send RIP
messages
rip output
Optional
Enabled by default
Configuring a RIP version
You can configure a RIP version in RIP view or interface view under the following conditions.
• If neither global nor interface RIP version is configured, the interface sends RIPv1 broadcasts and
can receive the following packets: RIPv1 broadcast, RIPv1 unicast, RIPv2 broadcast, RIPv2 multicast,
and RIPv2 unicast.
• If an interface has no RIP version configured, it uses the global RIP version; otherwise it uses the RIP
version configured on it.
• With RIPv1 configured, an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts
and RIPv1 unicasts.
• With RIPv2 configured, a multicast interface sends RIPv2 multicasts and can receive RIPv2 unicasts,
broadcasts, and multicasts.
• With RIPv2 configured, a broadcast interface sends RIPv2 broadcasts and can receive RIPv1
unicasts and broadcasts, and RIPv2 broadcasts, multicasts, and unicasts.
Follow these steps to configure a RIP version:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––
Specify a global RIP version version { 1 | 2 }
Optional
By default, if an interface has a RIP
version specified, the version takes
precedence over the global one. If
no RIP version is specified for an
interface, the interface can send
RIPv1 broadcasts, and receive
RIPv1 broadcasts and unicasts,
and RIPv2 broadcasts, multicasts,
and unicasts.
Return to system view quit —
Enter interface view
interface interface-type
interface-number
––