H3C Technologies H3C S10500 Series Switches - Manual (Page 297)

282
Task Remarks
Configuring a priority for OSPFv3 Optional
Configuring OSPFv3 route redistribution Optional
Configuring OSPFv3 timers Optional
Configuring a DR priority for an interface Optional
Ignoring MTU check for DD packets Optional
Disable interfaces from receiving and sending
OSPFv3 packets
Optional
Tuning and optimizing OSPFv3
networks
Enable the logging of neighbor state changes Optional
Configuring GR Restarter Optional
Configuring OSPFv3 GR
Configuring GR Helper Optional
Configuring BFD for OSPFv3 Optional
Enabling OSPFv3
Configuration prerequisites
Before enabling OSPFv3, complete the following tasks:
• Make neighboring nodes accessible with each other at the network layer
• Enable IPv6 packet forwarding
Enabling OSPFv3
To enable an OSPFv3 process on a router, you must enable the OSPFv3 process globally, assign the
OSPFv3 process a router ID, and enable the OSPFv3 process on related interfaces.
A router ID uniquely identifies a router within an AS. You must specify a unique router ID for each OSPFv3
router within the AS to ensure normal operation. If a router runs multiple OSPFv3 processes, you must
specify a unique router ID for each process.
An OSPFv3 process ID has only local significance. Process 1 on a router can exchange packets with
process 2 on another router.
Follow these steps to enable OSPFv3:
To do… Use the command… Remarks
Enter system view system-view —
Enable an OSPFv3 process and
enter its view ospfv3 [ process-id ] [ vpn-instance
vpn-instance-name ]
Required
By default, no OSPFv3 process is
enabled.
Specify a router ID router-id router-id Required
Enter interface view
interface interface-type
interface-number
—