ProSoft Technology 5105-103M-PDPS - Manual (Page 21)

5105-103M-PDPS ♦ ProLinx Gateway Start Here
IEC 60870-5-103 Master to PROFIBUS Slave Gateway User Manual
ProSoft Technology, Inc. Page 21 of 144
November 24, 2010
Step 2: Configure the Port Communication Parameters
The user should configure the port communication parameters in order to enable
data transfer between the master and the slave(s). The port communication
parameters include baud rate, parity, RTS ON, RTS OFF, and Minimum Delay.
The IEC 60870-5-103 protocol uses two baud rates: 19200 or 9600 kb/s and
even parity.
Refer to the [IEC-870-5-103 Master Port 0] section in the configuration file in
order to configure the communication parameters for the 103M port:
You must also configure the port jumpers to select the correct communication
mode: RS-232, RS-422, or RS-485.