ProSoft Technology 5105-103M-PDPS - Manual (Page 34)

Start Here 5105-103M-PDPS ♦ ProLinx Gateway
User Manual IEC 60870-5-103 Master to PROFIBUS Slave Gateway
Page 34 of 144 ProSoft Technology, Inc.
November 24, 2010
Override Value
If the Override Flag is set to "Yes", you can use this setting to always force a
control parameter to a fixed value. Use Enable code C
ONDITIONAL
and the
database value for the command to determine when the value should be written.
1.7.2 [IEC-870-5-103 Master]
This section establishes the total number of slaves to communicate with through
both application serial ports.
[IEC-870-5-103 Master]
Session Count : 1 #1 to 32 - maximum number of slaves on all channels
Session Count
1 to 16
This parameter specifies the maximum number of sessions (slaves) to interface
with the module's 103M application ports. This value represents the total number
of slaves on all ports.
1.7.3 [IEC-870-5-103 Master Port x]
These settings configure the communication parameters for each application port
on the module. The following illustration shows typical settings for a Master port.