Canon EOS R5 C VR Creator Kit with RF 5.2mm f/2.8 Dual Fisheye Lens - Manual (Page 44)

Adju s ting the Blac k Balance
44
Adju s ting the Black Balance
In CAMERA mode, you can have the camera adjust the black balance automatically when ambient temperature
changes considerably or if there is a noticeable change in a true black video signal.
1 Attach the body cap to the len s mount and s et the camera to CAMERA mode.
• If a lens was attached, turn off the camera and remove the lens. Place the body cap back on the lens mount
and turn on the camera.
2 S elect > [
v
Camera S etup] > [ABB] > [OK].
• The automatic black balance procedure will start. It may take about 1 minute depending on the frame rate.
• If the sensor is not completely shielded from light, [Error] will appear on the screen. Repeat the procedure
from the beginning.
NOTES
Adjusting the black balance is necessary in the following cases:
- When using the camera for the very first time or after a long period of not using it.
- After sudden or extreme changes in ambient temperature.
- After changing the sensor mode.
- After activating or deactivating slow & fast motion recording (including switching to another special recording
mode).
- After changing the shooting frame rate, when slow & fast motion recording is activated.
- After resetting the camera’s settings.
• During the adjustment of the black balance, you may notice some irregular displays appear on the screen. This
is not a malfunction.