Minolta Magicolor 3100 Series - Manual (Page 110)

2-110
2.7 Operation of EEPROM
Click the “EEPROM” button, and the following screen will appear when the “NV Data” tab is selected.
From this screen, the dialog related to the NVRAM (Non-Volatile Memory) is executed.
2.7.1 Direct Read/Write
The “Address” field and “Data” field are displayed on the screen when the “NV Data” tab is selected.
Entering an address and data here allows you to directly read/write the desired NVM area.
This file is intended to be used by a MINOLTA-QMS Level 3 Technical Support
Engineer to diagnose problems with data in the NVRAM. Refer to the NVM Readme.txt
file in the folder where the Hanabi Service Commander was installed.
Direct Read
1) Enter an arbitrary address in the Address field, and press the “Enter” key.
2) The result is displayed in the information display area.
Successful termination Read: XXXX (Address) - XX (Data)
Read inhibited area Read: XXXX (Address) - The address does not exist.
Direct Write
1) Enter an arbitrary address in the Address field and desired data in the Data field, then press the “Enter”
key.
2) The result is displayed in the information display area.
Successful termination Write: XXXX (Address) - XX
Read only Write: XXXX (Address) - You cannot write to this address.
The address and data to be entered are hexadecimal numbers. The result is displayed
also with hexadecimal numbers.