13 printing area, 13 printing area -410 – Minolta Magicolor 3100 Series User Manual
Page 410
8-410
This function specifies the IOT performance when the controller did not have the × 2
feeders satisfy the following performance.
*1:Process control means TC control, potential control, cleaning cycle, REGI control
and that the engine stops paper feeding for a certain time during the continuous
printing operation.
*2:The print may not start for a certain time after receiving the start command due to
prior job running conditions.
Refer to Chart 6 Operational Principal, for details of Process control.
Reference: Unit "PPM" stands for "prints per minute" indicating number of prints per minute.
4.13 Printing Area
4.13.1 Usable paper size
Minimum and maximum paper size usable for this printer are as follows:
Minimum usable paper size:Width 88.9mm (3.5inch) × length 139.7mm (5.5 inch)
(when using MSI)
Maximum usable paper size:Width 215.9mm (8.5 inch) × length 355.6mm (14 inch)
(when using MSI).
4.13.2 Maximum printable area
Maximum area where image can be printed is as follows:
Width: 210.9mm (8.3 inch) × length: 351.6mm (13.8 inch)
4.13.3 Guaranteed printing area
Area for which the image quality is guaranteed as follows:
Area except for 4mm (0.1575 inch) from edges of the paper.
Maximum area for which the image quantity is guaranteed as follows:
Width: 207.9mm (8.2 inch) × length: 347.6mm (13.7 inch)
Paper mode
Continuous printing speed
Standard mode
(600dpi)
Fine mode
(1200dpi)
High gross mode
(600dpi)
Simplex
(ppm)
Duplex
(ipm)
Simplex
(ppm)
Duplex
(ipm)
Simplex
(ppm)
Duplex
(ipm)
Plain paper/Woodfree paper
mode (A4/LET SEF)
16
10
8
5
8
5
Thick aper/Label mode
(A4/LET SEF)
8
–
8
–
–
–
OHP mode
8
–
8
–
–
–
Envelop/Postcard mode
8
–
8
–
–
–