Minolta Magicolor 3100 Series - Manual (Page 202)

3-200
RRP6.7 ROLL DUP (PL6.1.12)
Figure: ROLL DUP Removal
Removal
1) Remove the COVER ASSY FRONT HEAD. (RRP1.2)
2) Remove the COVER MSI. (RRP1.11)
3) Remove the TRAY ASSY MSI. (RRP1.12)
4) Remove the COVER ASSY FRONT. (RRP1.13)
5) Release the hook at 1 position of the GEAR 30 (PL6.1.10) secured to the shaft of the ROLL DUP from
the CHUTE ASSY OUT (PL6.1.1) of the printer.
6) Remove the GEAR 30 from the shaft of the ROLL DUP.
7) Extract the BEARING EARTH (PL6.1.11) securing the left shaft of the ROLL DUP to the CHUTE ASSY
OUT.
8) Remove the E-ring securing the right shaft of the ROLL DUP to the CHUTE ASSY OUT.
9) Extract the BEARING (PL6.1.16) securing the right shaft of the ROLL DUP to the CHUTE ASSY OUT.
10) Raise the right shaft of the ROLL DUP above the CHUTE ASSY OUT, shift it from the bearing bore
and pull out the ROLL DUP.
Replacement
Replace the components in the reverse order of removal.