Minolta Magicolor 3100 Series - Manual (Page 135)

Chapter 3 Removal and Replacement Procedures
3-133
Removal
1) Release the latch at B from the printer and open the FRONT ASSY IN (PL5.1.1) together with the
CHUTE ASSY OUT (PL6.1.1).
2) Remove 2 screws securing the COVER ASSY FRONT IN to the FRONT ASSY IN.
3) Release the latch at A from the printer and open the CHUTE ASSY OUT.
In the following process, do not separate the COVER ASSY FRONT IN and LINK:R too
far since they are connected.
4) Pull out the COVER ASSY FRONT IN slightly from the FRONT ASSY IN.
5) Release the LINK LEVER: R shaft from the leaf spring at the back of the COVER ASSY FRONT IN
and remove the COVER ASSY FRONT IN.
Replacement
Replace the components in the reverse order of removal.