Minolta Magicolor 3100 Series - Manual (Page 122)

3-120
1.2 Description of procedures
✧ "RRP X,Y "AAAAA" at the top of procedures represent the parts AAAAA are to be removed and
replaced.
✧ "(PL X.Y.Z)" following the parts name in procedures represent that the parts are those of the plate (PL)
"X.Y", item "Z" in Chapter 5, Parts List. Their forms, replacing position or other conditions can be seen
in Chapter 4, Parts List.
✧ In the procedures, directions are represented as follows.
▼ Front: Front when you are facing the front of this laser printer.
▼ Rear: Inner direction when you are facing the front of this laser printer.
▼ Left: Left hand when you are facing the front of this laser printer.
▼ Right: Right hand when you are facing the front of this laser printer.
Figure: Definition of Printer Orientation
✧ “◆ In case of _____ specifications" in the procedures indicate that service operation should be provided
only to laser printer of specified specifications (service operation should not be provided for laser printer
of specifications not covered).
✧ "RRP X.Y" in the midst or at the end of sentences in the procedures indicate that work procedures
related with the "RRP X.Y" are described.
✧ The screws in the illustrations should be removed using a plus (+) screwdriver unless otherwise
specified.
✧ A black arrows in the illustrations indicate movement in the arrow mark direction.
Numbered black arrows indicate movement in the order of the numbers.
✧ For the positions of the connectors (P/J), refer to Chapter 7, Wiring Diagrams and Signal Information.